Build a Go-Kart like a Champ
Share this

Guidelines and tips that’ll only take you a day

Go-karts: They're the most fun a kid can have on four wheels. We've got the plans and list of parts you need to build one with your mentee this Saturday and have him cruising around before sundown. (Just don't forget the helmets and seatbelts.)

Download the schematic here. These plans (or ones from other sites like have the dimensions for the parts, particularly those that make the frame. We’ve provided some extra help here:


The Frame

Use a hacksaw or chop saw to cut metal stock to length. Clamp the steel in a vise and file or grind the cut edges smooth. Using a MIG welder, tack together the parts to check for a good fit, and make final welds to complete the frame.

Go-Kart schematic

Weld an upper steering block to the top of the kart's steering post. Weld the lower steering block to the front of the frame. Screw the steering wheel to the steering shaft and thread the shaft assembly through the upper and lower blocks. Bolt a pair of spherical rod ends to the steering arm at the bottom of the shaft, using nylock nuts.

Weld spindle brackets to the front corners of the frame. Bolt the tie rods' opposite ends to the brackets' arms and connect the rods to both ends. Thread each bracket's stub axle into the front wheels' hubs. Mount the front tires on rims and bolt the rims to the hubs. Consider adjusting the positions of the steering shaft and tie rods until the steering performs properly.

Rear Axle

Weld bearing hangers to the bottom face of the frame's ten-inch rear legs. Center the sprocket, Uni-Hub, and brake drum on the axle. Wedge bearings between a pair of bearing cassettes and use the hardware in a bearing kit to fasten the cassettes to both hangers. (Expect to adjust the axle parts again.) On the axle ends, mount wheel hubs, fit rear tires onto the rims, and bolt the rims to the wheel hubs.


Buy accessories together with the engine to ensure compatibility. Weld a mounting plate to the rear center of the frame, and bolt the engine to it. Add a clutch to the engine crankshaft by using set screws in the clutch hub. Slide the Uni-Hub along the axle to align the axle sprocket with the clutch sprocket. Weld a bent 3/8-inch rod to the frame so it crosses in front of the brake drum to anchor the brake band. Tighten the set screws on the Uni-Hub, drum, and bearings.

Loop chain around both sprockets. Remove links as needed to adjust the chain. It should have a half-inch of play.


Attach brake and throttle cables to the left and right foot pedals. Lead cables to the rear and fasten the sheaths to the frame. Pull cables just to the point of tension. Use wire stops to pin the brake cable to the upper end of the brake band so that the band can cinch around the drum to arrest the axle's motion. Pin the throttle cable to the engine throttle in the idle position. Mount a kill switch; lead the cable to the engine.

Start the engine with the kart on blocks to test the pedal connections. If you wish, add a floorboard so that the driver won't kick the tie rods (or the ground).

Make a seat by stapling vinyl and foam cushioning to plywood. Bolt it to the seat post and the frame.

Put a helmet on the driver. Have some fun.

Popular Mechanics is a classic magazine of popular technology. First published January 11, 1902, by H. H. Windsor, it has been owned since 1958 by the Hearst Corporation.

Go to Site